Basic Settings - Kussmaul Electronics Kussmaul Chief Auto Charge Guide D'utilisation

Basic Settings

Under Basic Settings, you may configure any of the battery banks
designated as BAT1, BAT2, and BAT3. Under this setting, you
can also copy the battery settings onto a USB drive as well as
copy from a USB drive that contains battery settings from another
unit.
Getting to
1. From any screen, tap

Basic Settings

screen.
2. From the Home screen, tap
Main Menu screen.
3. Tap Basic Settings to enter Basic Settings
screen.
Basic
Settings
Notifications
975-1023-01-01
to go to the Home
to go to the
Main Menu Basic Settings
BAT1 BAT2 BAT3
Advanced
LFP Flooded Flooded
Settings
Float Float 3 Stage
60 Amp 40 Amp 40 Amp
Information
Recall Copy
>>
from USB to USB
Changing the The charger can simultaneously charge three
Battery Type separate battery banks with two different
chemistries, that is, one type of battery
connects to BAT1 while both BAT2 and BAT3
connect to batteries of the same type.
NOTE: Any battery setting applied to BAT2 will
automatically be applied to BAT3 and vice
versa.
1. From Basic Settings tap the appropriate
battery bank (either BAT1, BAT2, or BAT3).
BAT1
LFP
Float
60 Amp
Recall
from USB
2. Tap Battery Type.
3. Select by tapping the correct battery type
listed below. For information on the correct
battery type installed in your system, consult
your installer or the battery label.
Flooded
AGM
LFP
Basic Settings
Basic Settings BAT1 Setup
BAT2 BAT3
Battery Type
Flooded Flooded
Charge Mode
Float 3 Stage
Charge Current
40 Amp 40 Amp
Charge Time
Copy
>>
to USB
Enable Equalize Copy from Battery
BAT1 Type
GEL
ODY
Custom
41