Front Panel - Kussmaul Electronics Kussmaul Chief Auto Charge Guide D'utilisation

Front Panel

Front Panel
Figure 1 Front Panel
A
B
C
D
A
ELECTRICAL SHOCK HAZARD
Replace the wiring compartment cover before turning on
n
power to this equipment.
Use a torque screwdriver to tighten both the captive nut
n
panel screws to 5 in-lb (0.56 N-m) torque to ensure a
required tool access to the wiring compartment.
Failure to follow these instructions can result in death, serious
injury, or equipment damage.
6
E
WARNING
Item
A Mounting brackets are used to permanently install the product.
The brackets' position can be individually moved to the sides to
allow variations in how to anchor the unit securely. For more
information, see Mounting Bracket Patterns on page 23.
B Onboard control and status display panel or simply
onboard display panel (see Onboard Control and Display
Panel on page 8 for more information) for controlling the Auto
Charge settings and for monitoring charger status and charging
current.
C Wiring compartment cover protects the DC and AC terminals,
as well as the communication and BTS ports. Remove and replace
when installing cables. Also provides access to the DC fuse in the
event of an accidental reverse polarity condition.
D Captive nut panel screws for loosening and securing the wiring
compartment cover.
E Air vent for air exchange/circulation.
ELECTRICAL SHOCK HAZARD
Disconnect the batteries and AC power before opening the wiring
compartment cover.
Failure to follow these instructions will result in death or serious
injury.
Kussmaul Chief Auto Charge Battery Charger Owner's Guide
Description
DANGER