Kussmaul Electronics Kussmaul Chief Auto Charge Guide D'utilisation page 57

Basic Settings
6. Tap PLC Current. Change the value using
the + and – controls. The minimum and
maximum values are 5 and 50, respectively.
Amps
7. Tap
Tap SAVE CHANGES save the new setting
or EXIT WITHOUT CHANGES to disregard
any new setting.
8. Tap
SAVE CHANGES save the new setting or
EXIT WITHOUT CHANGES to disregard any
new setting.
44
BAT1 Charge Current BAT1 PLC Current
60 50
Amps
[5 - 60] [5 - 50]
PLC Current
>>
to go back to the previous screen.
to go back to the Home screen. Tap
Changing the You may customize the range of time the
Charge Time charger can actively remain charging a battery.
1. From Basic Settings tap the appropriate
battery bank (either BAT1, BAT2, or BAT3).
BAT1
LFP
Float
60 Amp
Recall
from USB
2. Tap Charge Time. Default value is 3 hrs.
3. Change the Maximum Absorb Time of the
battery using the + and – controls. Value
ranges from 1 to 8.
BAT1 Max. Abs Time
Hours
[1 - 8]
4. Tap
Tap SAVE CHANGES save the new setting
or EXIT WITHOUT CHANGES to disregard
any new setting.
5. Tap
SAVE CHANGES save the new setting or
EXIT WITHOUT CHANGES to disregard any
new setting.
Kussmaul Chief Auto Charge Battery Charger Owner's Guide
Basic Settings BAT1 Setup
BAT2 BAT3
Battery Type
Flooded Flooded
Charge Mode
Float 3 Stage
40 Amp Charge Current
40 Amp
Charge Time
Copy
>>
to USB
Enable Equalize Copy from Battery
3
Min. Abs Time
to go back to the previous screen.
to go back to the Home screen. Tap