Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Do not operate machine before having read
the operating instructions, understood all the
notes and assembly the machine as
described here.
Keep the instructions in a safe place for future use.
Contents
EC Declaration of Conformity
according to EC directive: 2006/42/EC
We,
ATIKA GmbH & Co. KG
Schinkelstraße 97
59227 Ahlen - Germany
herewith declare under our sole responsibility that the product
Tischkreissäge (Circular Saw Bench) type 250 ECO
Serial number: see last page
is conform with the above mentioned EC directives as well as with
the provisions of the guidelines below:
2004/108/EC and 2006/95/EC.
Following harmonized standards have been applied:
EN 61029-1:2009; EN 61029-2-1:2002; EN 55014-1:2006;
EN 61000-3-2:2006; EN 61000-3-3:1995+A1+A2,
EN 55014-2:1997+A1
Keeping of technical documents at:
ATIKA GmbH & Co. KG - Technical department - Schinkelstr. 97
59227 Ahlen - Germany
Ahlen, 01.04.2010
A. Pollmeier, management
Extent of delivery
After unpacking, check the contents of the box
That it is complete
Check for possible transport damage
Report any damage or missing items to your dealer, supplier or
the manufacturer immediately. Complaints made at a later date
will not be acknowledged.
1
• Circular saw T 250 ECO including
17
− Power cable and plug
17
− TCT saw blade ∅ 250
17
− Splitting wedge
18
• Supporting leg (4x)
18
• Connection strut - short (2x)
18
• Connection strut - long (2x)
19
• Leg (2x)
20
• Safety guard with exhaust outlet
21
• Longitudinal stop
21
• Table length extension
23
• Pushstick
24
• Extraction hose
25
• screw bag
25
• 2 spanners for replacing saw blade
25
• Operating manual
25
26
Characteristic data of noise
84
89
DIN EN ISO 3746 / DIN EN ISO 11202 / ISO 7960 Appendix A
Use of the machine as a bench to circular saw with standard
circular saw blade.
No-load
Load
The factor of measurement uncertainty is 3 dB.
The values given are emission values and must therefore not
simultaneously represent safe workplace values too. Although there is
a relationship between emission and immersion levels, it can be
reliably deduced whether additional precautionary measures are
necessary or not. Factors, which can influence the immersion level
currently existing at the workplace include the duration of the effects,
the special type of the workroom, other noise sources, etc. e.g. the
number of machines and other adjacent processes. The permissible
workplace values can also vary from country to country. This
information should however enable an improved assessment of the
danger and risk to be carried out.
Noise power level
Sound pressure level at
L
= 99.5 dB(A)
L
WA
L
= 111.1 dB(A)
L
WA
the workplace
= 87.3 dB(A)
pA
= 99.2 dB(A)
pA
17
Publicité
Chapitres
Table des Matières
