Ametek Sorensen XDL II Série Mode D'emploi page 23

# Code
00
01
02
03
20
21
22
23
24
25
26
30
31
33
40
41
42
91
92
93
94
98
99
Factory Default Settings
The ex-factory default settings (which will apply at first power-up) are as follows:
Range:
Voltage:
Current Limit:
OVP:
OCP:
Output:
# Settings:
22
Function
Main Output always off at power-up (factory default)
Main Output status at power-up the same as at last power-down
Aux Output (T models only) always off at power up (factory default).
Set with control assigned to Output 1.
Aux Output (T models only) status at power up the same as at last power down.
Set with control assigned to Output 1.
Alarm output 'open' for main Output off, 'closed' for main Output on
Alarm output 'closed' when Aux Output is in Current Limit.
Set with control assigned to Output 1; applies to Output 1 alarm only.
Alarm output 'closed' when over-temperature trip occurs
Alarm output 'closed' when sense trip occurs
Alarm output 'closed' when over-current trip occurs
Alarm output 'closed' when over-voltage trip occurs
Alarm output 'closed' when any trip occurs (factory default)
Buzzer off
Buzzer on (factory default). A single beep indicates confirmation, a double beep
indicates a wrong entry.
Lock/Unlock settings. Note that the AUX output settings are locked with Output1.
Jog digit flashes, JOG indicator only flashes when jog is 'hidden'
JOG indicator always flashes, except when 'hidden' (factory default)
JOG indicator doesn't flash, except when 'hidden' (lazy flash)
Loads default calibration parameters. Refer to Service Guide
Shows firmware version number in the display
Sets these # settings to their factory default
Loads Factory Default settings (see below)
Clears all the output's set-up memories. AUX output always cleared with O/P1.
In LINK mode, clears all memories in all modes (O/P1, O/P2, AUX & LINK).
Enter calibration mode. Refer to Service Guide.
XDL 35-5: 35V/3A
XDL 35-5: 1.000V
XDL 35-5: 1.000A
XDL 35-5: 40V
XDL 35-5: 5.5A
Output off; local Sense
00 Main Output always off at power-up
02 Aux Output always off at power up (an Output 1 # function only).
26 Alarm output 'closed' when any trip condition occurs
31 Buzzer on
41 JOG indicator always flashes; 'lazy' flash when hidden
XDL 56-4: 56V/2A
XDL 56-4: 1.000V
XDL 56-4: 1.000A
XDL 56-4: 60V
XDL 56-4: 4.4A