Transport And Handling; Machine Identification; Transport; Handling - Nuova Simonelli AURELIA II Manuel D'instructions

3.

TRANSPORT AND HANDLING

3.1 MACHINE
IDENTIFICATION
Always quote the machine serial number in all
communications to the manufacturer, Nuova
Simonelli.
3.2

TRANSPORT

The machine is transported on pallets which
also contain other machines - all boxed and
secured to the pallet with supports.
Before carrying out any transport or handling
operation, the operator must:
as well as a set of overalls which must be
elasticated at the wrists and ankles.
The pallet must be transported using a suit-
able means for lifting (e.g., forklift).
3.3

HANDLING

RISK OF IMPACT
OR CRASHING
During all handling operations, the operator
must ensure that there are no persons,
objects or property in the handling area.
The pallet must be slowly raised to a height
of 30 cm (11,8 in) and moved to the loading
area. After first ensuring that there are no
persons, objects or property, loading opera-
tions can be carried out.
Upon arrival at the destination and after
ensuring that there are no persons, objects
or property in the unloading area, the prop-
Fig. 9
er lifting equipment (e.g. forklift) should be
used to lower the pallet to the ground and
then to move it (at approx. 30 cm (11,8 in)
from ground level), to the storage area.
RISK OF IMPACT
OR CRASHING
Before carrying out the following operation,
the load must be checked to ensure that it is
in the correct position and that, when the
supports are cut, it will not fall.
The operator, who must first put on work
gloves and protective footwear, will proceed
to cut the supports and to storing the prod-
uct. To carry out this operation, the techni-
cal characteristics of the product must be
consulted in order to know the weight of the
machine and to store it accordingly.
4.
CAUTION
After unpacking, assess that the machine and
its accessories unit are complete, then proceed
as follows:
NOTE: the unit grooves have to face upwards,
CAUTION
It is advisable to install a softener (1) and then
a mesh filter (2) on the external part of the
plumbing system, during preliminaries and after
levelling the machine.
INSTALLATION
AND
PRELIMINARY
OPERATIONS
surface;
insert into the cylindrical unit;
inside the unit;
allotted setting for the machine's adjustable
feet;
ble feet;
as shown in the following illustration.
-
Fig. 10
47