Use; Commissioning Procedure Or After Boiler Maintenance (T3 Version); After Boiler Maintenance (T3 Version); Turning The Machine On - Nuova Simonelli AURELIA II Manuel D'instructions

6.

USE

Before starting to use the appliance, the operator
must be sure to have read and understood the
safety prescriptions contained in this booklet.
6.1 COMMISSIONING
PROCEDURE OR
AFTER BOILER
MAINTENANCE
(T3 VERSION)
When commissioning the machine for the first
time or after carrying maintenance switch ON
the machine using the main switch positioned
lower down and on the right and proceed as
follows:
DISENABLED" appears on the display pro-
ceed as follows in step three.
2) If the display reads "OFF" press the ON/
OFF
DISABLED" and then proceed as described
in step 3.
3) Switch on the machine using the ON/OFF
key and automatically after the
machine has switched on, some water will
be poured from the groups for about 45
seconds to make sure that the coffee boiler
tanks have been properly filled.
This cycle cannot and must not be inter-
rupted.
If this cycle is interrupted due to a power
outage or if the machine is accidentally
switched off from the main switch, the next
time the machine is switched on, the cycle
will be started again for approximately 45
seconds more.
50
6.2 TURNING THE
MACHINE ON
SWITCH ON: plug the machine into the
power socket and press the
switch "A" so it is in position "I";
the machine will switch on.
Pressing the switches "B" and
"C" in the "I" position will switch
on the LEDs, independently of
the position of switch "A".
B C
WARNING
If the self-diagnostics report anomalies or
failures, the operator MUST NOT intervene.
Please contact the Assistance Centre.
The lit display will show the firmware version
for about 1 second:
Release firmware 0.37.1
NOTE: The machine is not operational, since
the main switch only powers the elec-
tronic card.
For electronic card maintenance, turn the
machine off by means of the external main
A
switch or disconnect the plug.
Fig. 16
MANUAL SWITCHING ON/OFF
Automatic On/Off NOT PROGRAMMED
NOTE: make sure that the general switch is
always on the position "I".
SWITCH ON:
®
®
OFF
WARNING
press the On/Off button
for about 2 seconds until the
light switches on and the buzz-
er makes a beep sound.
The control unit will start up an
auto diagnosis cycle to check
the functions, all the selection
keys will light up.