Risk Of Electric Shock - Nuova Simonelli AURELIA II Manuel D'instructions

Masquer les pouces Voir aussi pour AURELIA II:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

The machine must be installed in
compliance with the local health
standards in force for plumbing sys-
tems.
Therefore, contact an authorized
plumber.
The device needs to be supplied with
water that is suitable for human con-
sumption and compliant with the
regulations in force in the place of
installation. The installation engineer
needs confirmation from the owner/
manager of the system that the water
complies with the requirements and
standards stated above.
This appliance must only be used as
described in this handbook. The
manufacturer shall not be liable for
any damage caused due to improper,
incorrect and unreasonable use.
This appliance is not suitable for use
by children or persons with reduced
physical, sensory or mental capabili-
ties, or by persons with a lack of
experience or knowledge, unless
supervised or given instructions.
The maximum and minimum storage
temperatures must fall within a range
of [-5, +50]°C.
The operating temperature must be
within the range of [+5, +35]°C.
At the end of installation, the device is
switched on and taken to rated operat-
ing conditions, leaving it in a state in
which it is "ready for operation".
The device is then switched off and
the whole hydraulic circuit is bled of
the first lot of water in order to
remove any initial impurities.
The device is then refilled and taken
to rated operating conditions.
After reaching the "ready for operation"
condition, the following dispensing
operations are carried out:
- 100% of the coffee circuit through the
coffee dispenser (for more than one
dispenser, this is divided equally);
- 100% of the hot water circuit through
the water dispenser (for more than one
dispenser, this is divided equally);
- opening of each steam outlet for 1
minute;
At the end of installation, it is good
practice to draw up a report of the
operations.
Basic rules must be observed when
using any electric appliance.
In particular:
do not touch the appliance when
hands or feet are wet;
do not use the appliance when
barefoot;
do not use the appliance when
barefoot;
CAUTION

RISK OF ELECTRIC SHOCK

do not pull the supply cord out of
the socket to disconnect it from
the mains;
do not leave the appliance
exposed to atmospheric agents
(rain, sun, etc.);
do not let the appliance be used
by children, unauthorised staff or
staff who have not read and fully
understood the contents of this
handbook.
During installation, the mains power
system needs to be equipped with a
disconnector switch to cut off each
phase.
Before carrying out any maintenance
operation, the authorised service
engineer will switch off the machine
and open the disconnector.
For all cleaning operations comply
exclusively with the instructions
given in this booklet.
If the appliance breaks down or fails
to work properly, switch it off. Any
intervention is strictly forbidden.
Repairs should only be made by the
manufacturer or authorized vice cen-
tres.
Only original spare parts must be
used.
Failure to observe the above, could
make the appliance unsafe.
For installation, the qualified electri-
cian must fit an omnipolar switch in
accordance with the safety regula-
tions in force and with 3 (0,12) or
more mm (in) between contacts.
Fig. 6
45

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Digit-t3

Table des Matières