Risk Of Electric Shock - Nuova Simonelli Aurelia Vip Plus Mode D'emploi

At the end of installation, the device
is switched on and taken to rated
operating conditions, leaving it in a
state in which it is "ready for opera-
tion".
The device is then switched off and
the whole hydraulic circuit is bled of
the first lot of water in order to remo-
ve any initial impurities.
The device is then refilled and taken
to rated operating conditions.
After reaching the "ready for opera-
tion" condition, the following dispen-
sing operations are carried out:
- 100% of the coffee circuit through
the coffee dispenser (for more than
one dispenser, this is divided
equally);
- 100% of the hot water circuit
through the water dispenser (for
more than one dispenser, this is divi-
ded equally);
- opening of each steam outlet for 1
minute.
At the end of installation, it is good
practice to draw up a report of the
operations.
42
Basic rules must be observed when
using any electric appliance.
In particular:
• do not touch the appliance when
hands or feet are wet;
CAUTION

RISK OF ELECTRIC SHOCK

• do not use the appliance when
barefoot;
• do not use extensions in bath or
shower rooms;
• do not pull the supply cord out of
the socket to disconnect it from
the mains;
• do not leave the appliance expo-
sed to atmospheric agents (rain,
sun, etc.);
• do not let the appliance be used
by children, unauthorised staff or
staff who have not read and fully
understood the contents of this
handbook.
During installation, the mains power
system needs to be equipped with a
disconnector switch to cut off each
phase.
Before performing any maintenance
operations, the authorised service
engineer must switch off the machine
and open the phase disconnector.
For all cleaning operations comply
exclusively with the instructions
given in this booklet.
If the appliance breaks down or fails
to work properly, switch it off. Any
intervention is strictly forbidden.
Contact qualified experts only.
Repairs should only be made by the
manufacturer or authorized service
centres. Only original spare parts
must be used. Failure to observe the
above, could make the appliance
unsafe.
For installation, the qualified electri-
cian must fit an omnipolar switch in
accordance with the safety regula-
tions in force and with 3 (0,12) or
more mm (in) between contacts.
To avoid dangerous overheating,
make sure the supply cord is fully
uncoiled.
Do not obstruct the extraction and/or
dissipator grids, especially of the cup
warmer.
The user must not replace the
appliance supply cord. If the cord is
damaged, switch off the appliance
and have a qualified technician chan-
ge the cord.
Single-phase appliances with current
above 15 A and three-phase applian-
ces sold without plugs are directly
wired to the mains power and there-
fore, it is not possible to use a plug.
Fig. 5