Programming Aurelia Esse - Nuova Simonelli Aurelia Vip Plus Mode D'emploi

AUTOMATIC CLEANING CYCLE
• To enter in the automatic cleaning cycle, you
must switch off the machine and switch on
the machine holding pressing
hot water and cupwarmer keys
during the initial Lamp-test. At the end of the
Lamp-test, starts to blinking the
and keys and the
long coffee) keys of each groups.
• By pressing the key starts the cleaning
cycle in the group selected. When the clea-
ning cycle is finished, is possible to begin
the rinsing cycle in the same group, by pres-
sing again the key.
• If you want make the rinsing cycle in an
other time it's enough to switch off the
machine: the control board memorizes the
cleaning cycles that you must end. With the
next turn on, the control board will enter
automatically in the cleaning cycle, without
pressing the and
• By pressing the and
for 2 seconds you escape from the cleaning
cycle in case there are not cycles to end,
otherwise the keys of the group, in that
you must finish the rinsing cycle, remain
with blinking.
• By holding pressing the
keys for other 2 seconds you force the esca-
pe from the cleaning cycle by resetting the
rinsing cycle.
• If the cleaning and the rinsing cycle is
ended, the key of the group switch
off; if there are no cycles to finish, the
machine return ready.
7.4
PROGRAMMING
AURELIA ESSE
DOSE PROGRAMMING
the
In the Aurelia Esse version only the doses of
water and timed steam can be programmed.
To access the programming state you must:
( o n e
• press the cup-warming key
seconds.
• The selection keys and the 1 long coffee key
belonging to the first unit will start to
flash on and off while the other delivery keys
of the other units will turn off.
HOT WATER
• Once the programming state has been
accessed, by pressing the
keys.
hot water delivery will be activated; once the
desired dose has been reached press the
keys
key again and the set delivery time
will be stored in the control unit.
TIMED STEAM
and
• Once the programming state has been
accessed, by pressing the
hot water delivery will be activated; once the
desired dose has been reached press the
key again and the set delivery time
will be stored in the control unit.
ADJUSTING LIGHTING INTENSITY
KEYBOARD
• Access programming according to the rela-
tive procedure.
• Adjust the light intensity of the keys by pres-
sing the first unit's 1 long coffee
more than once.
for five
NOTE: To exit programming press the
key.
ACTIVATING LEVELLING PUMP
• Access programming according to the rela-
tive procedure.
• Press and keep pressing the 1 long coffee
key belonging to the second unit.
• To set the activation of the pump during
levelling, once the programming state has
key, been activated,
key pressed.
The second unit key
by means of the first unit
pump setting will be visualized: if it is lit up
the pump will function during levelling; if it is
not lit up the pump will not be activated
during levelling.
By pressing the first unit
setting during levelling can be modified.
key,
NOTE: to exit the programming press the
key.
key
keep the second unit
will light up and
key the
key the pump
61