Dose Programming - Nuova Simonelli Aurelia Vip Plus Mode D'emploi

7.3
PROGRAMMING
AURELIA V

DOSE PROGRAMMING

To access the programming units, proceed as
follows:
NOTE: the procedure can be carried out with
the machine on.
• To access the dose programming state of
each unit press the first unit's continuous
delivery key for 5 seconds.
• The delivery keys will begin to flash on and
off.
• Access into the first unit's programming
allows you to set the machine's function
parameters.
COFFEE DOSE PROGRAMMING
To program the relative water doses for one of
the delivery keys, proceed as follows:
• fill the filter-holder with the correct dose of
coffee (the filter-holder can be single or dou-
ble depending on the key you wish to pro-
gram).
• Insert the filter-holder into the unit.
• Press one of the delivery buttons (see illu-
stration):
The delivery will start; once the desired
amount has been reached, press the conti-
nuous key.
• The delivery will stop and the chosen dose
key will turn off (the other keys will continue
to flash).
58
• Press the continuous key to exit pro-
gramming or to continue programming other
dose keys.
NOTE: This procedure is usable on all the
machine units except if carried out one
at a time; the other groups can carry on
normally.
HOT WATER PROGRAMMING
• Access the programming according to the
relative procedure.
• Press the hot water selection key
.
• Hot water delivery will start.
• Establish the desired hot water dose and
press the key again . .
• Press the continuous
programming or to continue programming
other selection keys.
Technician: To enable the pump while hot
water is being dispensed, enter the pro-
gramming mode for the first dispensing
group then press the continual button
for the second group.
• To change the settings, it is sufficient to
press the hot water button
button is not lit, the pump will not be enabled
while hot water is being dispensed; if the
button is lit while hot water is dispensed, the
pump will be activated.
• Press the continual button
second dispensing group to confirm the set-
ting.
TIMED STEAM PROGRAMMING
• Access the programming according to the
relative procedure.
• Press the steam selection key
• Steam ejection will start.
• Establish the desired dose of steam and
press the key again
• Press the continuous
programming or to continue programming
other selection keys.
AUTOMATIC CUP-WARMER PRO-
GRAMMING
• Access the programming according to the
relative procedure.
key to exit the
• Press the cup-warming selection key
.
• The delivery keys of the first and second
unit will respectively signal the allotted auto-
matic switching on and off times while the
continuous
units will flash on and off.
As described in the chart, each delivery key
has an associated value, the starting up
: if the time of the cup-warmer is given by adding
up the values of the first unit's lit-up keys.
The same counting method is used for the
cup-warmer switching off time with the keys
of the second unit.
for the
.
.
key to exit the
keys of the first and second