Cruise Control - EMAK 102 Manuel D'utilisation

6. Oil light (if fitted). It signals an engine lubrication
fault. Stop the engine immediately, check the oil
level and contact a service centre if the problem
persists.
6
7. Fuel gauge (if fitted). This can come in two types:
a) Level gauge = indicates the fuel level in the tank
as follows:
7a
from full to approx. from half full to
half full
b) Reserve gauge = starts flashing when fuel is in
reserve.
7b
NOTE
The reserve is approx. 2 litres of fuel,
which is enough for 30-40 minutes of normal work.

4.12 CRUISE CONTROL

(if present)
This device keeps the machine at the desired drive speed with-
out having to push the pedal (4.32).
in reserve
reserve
The mushroom-head button (4.12) has two positions:
«A» Pressed = Device disengaged (off)
«B» Pulled = Device on
– Turn on the device when
driving, the machine main-
tains the speed reached
at that time without having
to push the pedal (4.32).
– The device cannot be
used when driving in
reverse.
– When the device is on,
the pedal (4.32) cannot be
put into reverse («R»).
NOTE
Speed may vary from that set when going
up or down hill.
To turn off the device and restore pedal control (4.32) just:
– press the drive pedal (4.32) in the «F» direction
(forward gear);
or
– press the brake pedal (4.31).
In both cases the mushroom-head button (4.12) automatically
returns to position «A».
IMPORTANT
Always avoid pressing the mushroom-
head button (4.12) to turn off the device.
4.12
B
A
EN 17