EMAK 102 Manuel D'utilisation page 93

(2), rotate it so the spokes
point towards the seat and
push it in until the steering
wheel hub attaches to the
protruding ends of the pin
(3).
Fasten the steering wheel
in place using the screws
supplied (4 – 5 – 6), in the
indicated order.
Be careful to assemble
the cup washer (5) with
the concave part facing
down and tighten the
screw (6) with a pipe
wrench.
Fit the steering wheel
cover (1a) by clicking the
fasteners into place.
3.3 FITTING THE SEAT
Raise the adjustment
lever (3) and fit the seat
(1) in the slide (2), intro-
ducing it from the steering
wheel's side, till the seat
engages in one of the 6
positions.
EN 10
5
6
5
4
1
2
3
1a
4
2 1
At this point the seat is engaged and cannot be completely
removed unless the lever (4) is pressed, freeing it from its
retainer.
3.4 ASSEMBLY AND CONNECTING THE BATTERY
Position the battery (1) in its compartment under the seat.
Connect the red cable (2) to the positive terminal (+) and the
black cable (3) to the negative terminal (–) using the supplied
screws and following the illustrated sequence.
1
Fit the spring (4) to hold the battery in place and make sure all
the wires are in front of the battery so that they don't get caught
in the spring (4).
3
IMPORTANT
to the instructions in the battery's manual (
1 4
Always fully charge the battery according
6.2.3).
3
2