EMAK 102 Manuel D'utilisation page 120

PROBLEM
7. Engine stops when blades are engaged
8. The battery warning light does not turn off after
a few minutes' work
9. The oil warning light comes on while working
(if fitted)
10. The engine stops and an audible signal is
heard
11. The engine stops with no audible warning
12. The blades do not engage or do not stop
promptly when they are disengaged
13. Uneven cut and poor grass collection
LIKELY CAUSE
– you are not ready to engage the blades
– recharging of the battery insufficient
– problems in lubricating the engine
The protection of the electronic card has cut in due to:
– overvoltage caused by the charge regulator
– badly connected battery (poor contact)
– battery disconnected
– problems in the engine
– belt loosened
– problems in the electromagnetic clutch
– cutting deck not parallel to the ground
– blade cutting badly
– forward speed too high compared to height of grass
– collector channel is blocked
– cutting deck full of grass
SOLUTION
– check that the conditions allowing starting are
met ( 5.2.c)
– Contact your dealer
Turn the key immediately to «STOP»:
– top up the oil level ( 5.3.3)
– replace the filter (if the problem continues,
contact your dealer)
Turn the key to «STOP» and look for the cause of
the problem:
– Contact your dealer
– check connections ( 3.4)
– check connections ( 3.4)
– Contact your dealer
– Contact your dealer
– Contact your dealer
– check the tyre pressures ( 5.3.2)
– re-align the cutting deck to the ground
( 6.3.1)
– Contact your dealer
– reduce forward speed and/or raise the cutting
deck ( 5.4.5)
– wait for the grass to dry
– remove the grass-catcher and empty the
collector channel ( 5.4.7)
– clean the cutting deck( 5.4.10)
EN 37