End Of Work - EMAK 102 Manuel D'utilisation

Manual tipping
NOTE
Emptying the
grass-catcher can only be done
with the blades disengaged, other-
wise the engine stops.
– pull out the lever (1) (
and tip up the grass-catcher to
empty it;
– close up the grass-catcher so that
it hooks onto the pawl stop (2) and
put the lever (1) back into place.
Electrical tipping
NOTE
The dumping
switch operates only with the
blades disengaged.
– with the operator seated, keep the
button (3) ( 4.9.2) pressed until
the grass-catcher is completely
tipped over;
– once emptied, keep the button (4)
( 4.9.3) pressed until the grass-
catcher has completely gone down while checking that the
pawl (2) stays hooked on.
NOTE
At times the audible warning may be
heard at the moment of engaging the blade even when the
grass-catcher has been emptied (5).This is due to grass-cut-
tings left on the sensor of the micro-switch. To stop the signal,
1
4.9.1)
3
2
4
5
disengage the blades and then immediately engage them
again. If the warning sound continues, stop the engine, take
off the grass-catcher and remove any accumulated grass-cut-
tings from the sensor (5).
5.4.7 Unblocking the collector channel
Cutting very tall or wet grass, particularly at too high speed, can
cause the collector channel to become blocked.
Should this happen, it will be necessary to:
– stop forward movement immediately, disengage the blades
and stop the engine;
– take off the grass-catcher or stone-guard;
– remove the accumulated cuttings, reaching them from the exit
of the collector channel.
WARNING!
This job must only be performed with
the engine turned off.
5.4.8 End of mowing
When you have finished mowing, disengage the blades, lower
the engine speed and ride the machine with the cutting deck in
the highest position.

5.4.9 End of work

Stop the machine, put the accelerator lever in the «SLOW»
position and turn off the engine by putting the key into the
«OFF» position.
EN 25