EMAK 102 Manuel D'utilisation page 107

To change the position,
release the stop plate (2)
using a screwdriver and
extract the pin (3) and the
spring (4).
Move the wheel (1) to the
desired position, then replace
the pin (3), the spring (4) and
the stop plate (2) in the indi-
cated order, making sure the
pin head (4) is facing toward the inside of the machine.
WARNING!
This should always be performed
on both wheels, positioning them at the same height
WITH THE ENGINE OFF AND BLADES DISENGAGED.
Model 122
The three different front and rear wheel assembly positions
allow you to maintain a safe distance «A» between the cut-
ting deck edge and the ground.
To change the position, release the stop plate (2) using a
screwdriver and extract the pin (3) and the spring (4).
Move the wheel (1) to the desired position, then replace the
pin (3), the spring (4) and the stop plate (2) in the indicated
order, making sure the pin head (4) is facing toward the
inside of the machine.
WARNING!
This should always be performed
on all wheels, positioning them at the same height
WITH THE ENGINE OFF AND BLADES DISENGAGED.
EN 24
2
3
4
1 2
To start cutting:
– put the accelerator into the «FAST» position;
– bring the cutting deck to the highest position;
– only use the blade ( 4.7), on grass lawns, do not use the
blades on stony ground or when the grass is very high;
– start moving forwards onto the grass area very gradually and
with particular caution, as already described;
– adjust the forward speed and the cutting height (
according to the lawn condition (height, density and damp-
ness of the grass).
WARNING!
When cutting on sloping ground, the
forward speed must be reduced to ensure safe condi-
tions ( 1.2 - 5.5).
In any case, the speed should always be lowered if you note a
reduction in engine speed, since a forward speed that is too fast
compared to the amount of grass being cut will never mow the
grass well.
Disengage the blades and put the cutting deck in the highest
position whenever you need to get past an obstacle.
5.4.6 Emptying the grass-catcher
Do not let the grass-catcher become too full as this may block
the collector channel. When the grass-catcher is full there is an
intermittent audible warning.
At this point:
– lower the engine speed;
– go into neutral (N) ( 4.32) and stop forward movement;
– engage the parking brake on slopes;
– disengage the blades (
stop;
4.8)
4.7) and the audible signal will