Cleaning The Machine - EMAK 102 Manuel D'utilisation

When the engine is stopped, close the
fuel stopcock (1) (if fitted).
WARNING!
To avoid
backfire, put the accelerator in
the «SLOW» position for 20 sec-
onds before stopping the engine.
WARNING!
Always take
out the ignition key if leaving the machine unattended!
IMPORTANT
To keep the battery charged, do not
leave the key in the «ON» position when the engine is not run-
ning.

5.4.10 Cleaning the machine

After each mowing, clean the outside of the machine, empty the
grass-catcher and shake it to remove residual grass and earth.
WARNING!
Always empty the grass-catcher and
do not leave containers full of cut grass inside a room.
Clean the plastic parts of the body with a damp sponge using
water and detergent, taking care not to wet the engine, the elec-
trical parts or the electronic card located under the dashboard.
IMPORTANT
Never use hose-nozzles or harsh deter-
gents for cleaning the body and engine!
EN 26
WARNING!
grass accumulate in upper part of the cutting deck in
order to keep maximum machine efficiency and safety
levels.
After each use, accurately clean the cutting deck to remove any
grass remains or debris.
WARNING!
1
or animals away from the surrounding area when clean-
ing the cutting deck.
a) When washing the inside of the cutting deck and the col-
lector channel, the machine must be on firm ground with:
– the grass-catcher or
stone-guard fitted;
– the operator seated;
– the cutting deck on posi-
tion «1»;
– the engine running;
– the transmission in neu-
tral;
– the blades engaged.
Connect a water hose to each of the pipe fittings (1) one at a
time, and running water through for a few minutes each, with the
blades moving.
IMPORTANT
of the electromagnetic clutch:
– prevent the friction from coming into contact with oil;
– do not direct jets of high-pressure water directly onto the
clutch unit;
– do not clean the clutch with petrol.
Do not let debris and dry remains of
Wear eye protection and keep people
To avoid umpairing the efficient working
1