EMAK 102 Manuel D'utilisation page 94

IMPORTANT
To prevent the safety device in the elec-
tronics card from cutting in, never start the engine until the
battery is fully charged!
WARNING!
Follow the battery manufacturer's
instructions regarding safe handling and disposal.
3.5 GRASS-CATCHER SUPPORT ASSEMBLY
Fit the two brackets (1) on the rear plate (2), using for each
bracket three screws (3) which are supplied, as shown, without
fully tightening the nuts (4).
1
3
Attach the grass-catcher to the brackets and centre it with the
rear plate (2). Adjust the position of the two brackets (1) to the
stop (5) so that, when turning the grass-catcher frame, the pin
(6) slots into the seat (7) correctly.
4
5
1
2
Having checked that the grass-catcher rotates as above, tighten
the fixing nuts (4) securely.
3.6 ASSEMBLING THE LEVERS FOR TIPPING
THE GRASS-CATCHER
Electrical tipping
Position the lever axle
(1) in the notch of the
two plates (2) and
attach them on the
internal side of the
grass-catcher sup-
ports (3), using the
included screws (4) in
the sequence shown.
Connect the end of
the rod (5) of the lift-
ing piston to the lever
7
(6) with the pin (7)
6
and attach the two
snap rings (8).
Before attaching the grass-catcher to its supports, make sure
that the tipping lever moves properly.
4 3 4 1 4 3
8 (x 2)
1 2 8 7
6
EN
4
5
8
11