EMAK 102 Manuel D'utilisation page 110

Take off the grass-catcher, empty and rinse it, and then put it in
a position where it can dry quickly.
b) To clean the upper part of the cutting deck:
– lower the cutting deck completely (position «1»);
– blow a jet of compressed air through the right and left guard
slots.
5.4.11 Storage and inactivity for long periods
If you intend not to use the
machine for a long period
(more than 1 month), dis-
connect the battery cables
and follow the instructions in
the engine instruction ma-
nual.
Empty the fuel tank by dis-
connecting the tube (1) situ-
ated at the inlet of the fuel filter (2), and collect the fuel in a suit-
able container.
Reconnect the tube (1) making sure you position the clip proper-
ly (3).
Put the machine away in a dry place protected from weather
and, if possible, cover with a cloth (
The next time the machine is used, check that there are no fuel
leaks from the tubes, fuel stopcock or carburettor.
5.4.12 Card protection device
The electronic card has a self-resetting protector which breaks
the circuit if there is a fault in the electrical system. It results in
the stopping of the engine and an audible signal which can only
be stopped by removing the key.
The circuit automatically resets after a few seconds but the
cause of the fault should be ascertained and dealt with to avoid
2 3 1
re-activating the protection device.
WARNING!
Carefully remove any dry grass cut-
tings which may have collected around the engine or
silencer to prevent their catching fire the next time the
machine is used!
IMPORTANT
The battery must be kept in a cool and
dry place. Before a long storage period (more than 1 month),
always charge the battery, and then recharge before using
again ( 6.2.3).
9.4).
EN 27