Brake Pedal - EMAK 102 Manuel D'utilisation

4.31 BRAKE PEDAL

This pedal works the brake on the rear wheels.
4.32 DRIVE ENGAGEMENT PEDAL
This pedal engages drive in the wheels as well as modulating
the machine's forward and reverse speeds.
– To engage forward
drive just press it in
the «F» direction with
your toe-cap, noting
that increasing the
pressure on the pedal
progressively increas-
es the speed of the
machine.
– Reverse is engaged
by pressing the pedal
with the heel, in the
«R» direction.
– The pedal automati-
cally goes into neutral
«N» when released.
– The "neutral" condition
«N» is shown by the
lighting of a pilot lamp
(4.10.e).
EN 18
the machine is stopped.
wards or for reverse, when the parking brake (4.5) is
engaged, the engine stops.
4.33 LEVER TO RELEASE THE HYDROSTATIC
This lever has two positions as shown on the label:
4.31
«A»
«B»
4.32
this operation must be carried out only when the engine has
N
stopped with the pedal (4.32) at position «N».
F
R
B
4.33
A
WARNING!
Reverse must only be engaged when
NOTE
If the drive pedal is used, whether for-
TRANSMISSION
= Transmission engaged: for all usage conditions,
when moving and during cutting;
= Transmission released: considerably reduces the
effort required for moving the machine by hand, with
the engine turned off.
IMPORTANT
To avoid damaging the transmission unit,