Versions Of Snubbers And Spare Parts - Rohloff Gates SPEEDHUB 500/14 Manuel D'utilisation

Please note:
This re-adjustment of the belt tension is done with the tensioning mechanism of
the frame. In this example it is done with the adjustment bolts of the dropouts.
Proceed as you did when Mounting the Gates Carbon Drive Belt, this means
the correct alignment of the belt has to be guaranteed at all times while you
adjust the tension. You have to adjust both, the alignment and the tension.
Using the Snubber to keep the Gates Carbon Drive Belt from
ratcheting
If the Gates Carbon Drive is used with the Rohloff SPEEDHUB 500/14, a so-called "Snubber"
has to be installed. The Snubber guides the belt at the rear sprocket and prevents the
belt from ratcheting over the teeth. Ratcheting teeth can damage the inner carbon
structure of the belt. This can cause the belt to break when the bike is being used. If you
think that the inner structure of your belt might be damaged, you should replace the belt.

Versions of Snubbers and spare parts

Title
RDM Snubber
RDM Shimano Snubber
QR Snubber
Snubber Wheel
Snubber Scew
Spacer Kit
Please note:
The spacer kit must be ordered in addition to the snubber, if required
according to
the respective
www.carbondrive.net
24
mounting
Part Number
CDECDR
CDERDMS
CDECDQ
CDERO
CDESB
CDESK
the table (P. 25).
snubber variants
Application
Mounting on traditional derailleur
hanger
Mounting on Shimano DirectMount
derailleur hanger
Mounting via quick release
Mounting on OEM Dropouts
For Sparepart delivery
See Table on P. 25,
includes 2x 9mm Spacer,
cylinder screw M6x30
An overview of
and spare parts
the components
can be found
of
at: