Mounting The Front Sprocket At The Crank Adapter - Rohloff Gates SPEEDHUB 500/14 Manuel D'utilisation

Offset Kit
For further information please contact your Gates supplier
Offset Kit
Shim ring, bottom bracket
Shim ring, bottom bracket
41x35x1 Art. No. CDEW0
41x35x1 Art. No. 10300600
41x35x0,5 Art. Nro CDEW1
41x35x0,5 Art. No. 10300601

Mounting the Front Sprocket at the crank adapter

The sprocket is put over the crank arm and affixed with the sprocket bolts (which were
included with your crankset). As shown in illustration 1, the flange of the sprocket is
turned outward. To guarantee proper operation of the Gates Carbon Drive System, both
sprockets need to be exactly aligned with each other (illustrations 2 and 3). The belt
alignment cannot be adjusted on the rear sprocket of the Rohloff SPEEDHUB 500/14.
Therefore, you can only adjust it with the position of the front sprocket. The included
shim rings have been designed to facilitate this adjustment. For some bottom brackets
it is possible to adjust the alignment with shim rings (illustration 4). Please note the
mounting instructions from the particular bottom bracket manufacturer. An overview
of belt lines of the available Rohloff SPEEDHUB versions is shown in the following table.
12
mounting
Art. No.: 10300702-4bolt
Art. No.: 10300703-5bolt
Shim ring, 0,5mm
Shim ring, 0.5mm front
Front Sprockets
sprocket
10x16x0,5 Art. No. CDEW3
10x16x0,5 Art. No. 10300602
.
Shim ring, 1mm
Shim ring,1mm front
Front Sprockets
sprocket
10x16x1 Art. No. CDEW2
10x16x1 Art. No. 10300603
www.gatescarbondrive.com
23