Rohloff Gates SPEEDHUB 500/14 Manuel D'utilisation page 64

In this example, the rear wheel is moved towards the bottom bracket by
horizontally slidable dropouts. It might be necessary to loosen the screws of the
disc brake caliper. When you reach the smallest distance between the center of
the bottom bracket and the rear axle, fit the belt to the front sprocket as well.
5. Mechanisms used to tension the belt may vary by manufacturer. Always
follow the instructions of the
you now tension the belt
and the tensioning bolts inside the dropouts.
side (drive side), until the wheel sits evenly between both chainstays.
Please Note
Never try to pry the belt on, or "roll" it on by rotating the cranks. This may cause
inner structual damage which will result in the belt no longer being useful.
The handling illustrated above can damage the system!
12
mounting
on the drive side, using
mounting
4. Minimize
the axle of the bottom bracket
and the rear axle so that the belt
can be fitted to the front sprocket
without tension. The tools requird
to reduce the distance may vary
depending
Always follow the instructions of
the particular bicycle manufacturer.
particular manufacturer.
After tensioning the right
www.gatescarbondrove.com
the distance between
upon manufacturer.
In this example,
the sliding dropouts
2
17