Rohloff Gates SPEEDHUB 500/14 Manuel D'utilisation page 62

Mounting and removing the Gates Carbon Drive Rear Sprocket
The mounting that is used to mount a Gates rear sprocket on a Rohloff SPEEDHUB
500/14 hub is exactly the same as that of a regular chain sprocket. In the event
that you would like to exchange or replace the Gates rear sprocket on your
Rohloff SPEEDHUB 500/14 hub or would like to replace an existing hub having a
chain sprocket with a Gates sprocket, follow the appropriate instructions in your
Rohloff SPEEDHUB 500/14 manual for mounting and removing a chain sprocket.
Please note
The system of the Gates-Rohloff carrier M46x6 is no longer continued and replaced by
the Rohloff Spline Carrier (Art. No. 8540). This part is only available from Rohloff. The belt
line for both systems is identical. The suitable sprockets are shown in the following table.
Versions of rear sprockets
Teeth Description
19 Rohloff Spline
20 Rohloff Spline
22 Rohloff Spline
Partnumber
CDXR19ROS
CDXR20ROS
CDXR22ROS
Illustration 1:
Mounted Rear Sprocket on a
Rohloff SPEEDHUB 500/14
mounting
www.gatescarbondrove.com
2
15