Rohloff Gates SPEEDHUB 500/14 Manuel D'utilisation page 66

9. If you have loosened the bolts of the brake caliper for the mounting,
make sure to re-
the bowden
10. If the belt does not align with the front and rear flanges of the sprockets
after tightening all the bolts, one of the following actions will help you:
a. Adjustment of the belt alignment by fine adjustment of the rear wheel
b. Adjustment of the belt alignment at the crank (see Mounting the front sprocket)
11. Now follow the instructions for checking the belt tension.
12. Finally, check to make sure that the Snubber is correctly mounted.
Please note
Please note:
The following instructions are for frames with horizontal sliding dropouts. These are
used differently by various different manufacturers. Fora different frame version than The following instructions are for frames with horizontally slidable dropouts. These
described in the following example, please follow the instructions of the particular are used differently by various different manufacturers. For different frame version
manufacturer, or ask your certified retailer how to align and tension the belt. than described in the following example, please follow the instructions of the
particular manufacturer, or ask your certified retailer how to align and tension the belt.
It is also possible that the tension of the belt on your frame does not take place via the
dropouts but via an eccentric at the bottom bracket of the frame. In this case, please also
follow the appropriate mounting specifications of your bicycle or frame manufacturer.
Aligning the belt by adjusting the sliding dropouts
Aligning the belt by adjusting the slidable dropouts
14
mounting
tighten them
cable of your
mounting
now. If you
brake, be sure
www.gatescarbondrove.com
have unhinged
to put it back.
2
19