Rohloff Gates SPEEDHUB 500/14 Manuel D'utilisation page 65

Illustration 3:
Correct alignment of the belt
Illustration 3:
Correct alignment of the belt
7. Tension the dropouts on the drive side or loosening them on the non-
drive side
7. Tension the dropouts on the drive side or loosening them on the non-
wheel to achieve
drive side
check the belt alignment and re-adjust, if necessary. Make sure to maintain the
wheel to achieve
proper belt tension. Repeat this step until you reach the perfect belt alignment.
check the belt alignment and re-adjust, if necessary. Make sure to maintain the
proper belt tension. Repeat this step until you reach the perfect belt alignment.
Rotate the
it until it runs noiseless.
Rotate the
tension. Repeat
it until it runs noiseless.
tension. Repeat
8. Reconnect the torque arm (if used with your version) and the gear mech
of the hub. Please follow the instructions of the Rohloff SPEEDHUB500/14
8. Reconnect the torque arm (if used with your version) and the gear mech
manual for your version of the hub. Tighten all bolts of the rear wheel and
of the hub. Please follow the instructions of the Rohloff SPEEDHUB500/14
quick release elements, according to the manufacturer's torque specifications.
manual for your version of the hub. Tighten all bolts of the rear wheel and
quick release elements, according to the manufacturer's torque specifications.
18
mounting
steers the belt towards the flange of the rear sprocket. Adjust the rear
the right alignment of the belt. Turn the crank again, re-
steers the belt towards the flange of the rear sprocket. Adjust the rear
the right alignment of the belt. Turn the crank again, re-
crank again, check
crank again, check
these steps
Please
these steps
mounting
mounting
6. Rotate the cranks 10-15 times with
free turning back wheel. The belt
6. Rotate the cranks 10-15 times with
is aligned correctly
free turning back wheel. The belt
straight
is aligned correctly
straight
the alignment
Please consider
the alignment
until the belt
consider
until the belt
Illustration 4:
Incorrect alignment of the
Illustration 4:
belt
Incorrect alignment of the
belt
when it runs
without making
when it runs
without making noises.
of the belt and
always the needed belt
of the belt and
line is correct adjusted.
always the needed belt
line is correct adjusted.
www.gatescarbondrive.com
www.gatescarbondrive.com
2
2
noises.
adjust
adjust
13
13