Wheel Mounting And Removal - Rohloff SPEEDHUB 500/14 Notice Originale

Wheel mounting and removal

Switch the eBike System "off". Pay attention to manufactures operation manual.
Remove the battery from the eBike System. Pay attention to manufactures operation
manual.
Remove the rear wheel (with Rohloff E-14 Shifter Unit) as described in the Rohloff
SPEEDHUB 500/14 Owners Manual.
Re-mount the rear wheel in the reverse procedure as that written above.
Re-fit the eBike System battery. Pay attention to manufactures operation manual.
Switch the eBike System "on". Pay attention to manufactures operation manual.
Further important safety information with regards to use, mounting,
accessories, service, and repairs of the Rohloff SPEEDHUB 500/14 and the
Rohloff E-14 can be found at www.rohloff.de/en.
Disconnect the cable from the Rohloff E-14 Shifter Unit on
the rear wheel.
Attention:
Pay close attention to the „Cable and Plug
Connections" chapter!
Re-connect the Rohloff E-14 Shifter Unit with the eBike
System cable loom.
Attention:
Pay close attention to the „Cable and Plug
Connections" chapter!
18