Installation; Unpack And Inspect; Einbau; Ventil Auspacken Und Prüfen - Edwards PV10EK Mode D'emploi

Vannes pvek
Table des Matières

Publicité

3

Installation

3.1

Unpack and inspect

Remove all the packing materials and protective covers
and check the PVEK valve.
If the valve is damaged, notify your supplier and the
carrier in writing within three days; state the Item
Number of the valve together with your order number
and your supplier's invoice number. Retain the packing
materials for inspection. Do not use the valve.
If the valve is not to be used immediately, replace the
protective covers. Store the valve in suitable conditions,
as described in
Section
6.
© Edwards Limited 2007. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
3

Einbau

3.1
Ventil auspacken und prüfen
Sämtliches Verpackungsmaterial und alle
Schutzabdeckungen entfernen; dann das PVEK-Ventil
prüfen.
Wenn eine Beschädigung des Ventils festgestellt wird, so
müssen Lieferant und Spediteur hiervon innerhalb von
drei Tagen schriftlich in Kenntnis gesetzt werden; dabei
zusammen mit Ihrer Auftragsnummer und der
Rechnungsnummer des Lieferanten die Artikelnummer
des Ventils angeben. Die Verpackungsmaterialien zwecks
späterer Begutachtung aufbewahren. Ein beschädigtes
Ventil darf nicht benutzt werden.
Wenn das Ventil nicht für den sofortigen Einsatz
bestimmt ist, die Schutzabdeckungen wieder anbringen.
Das Ventil bei entsprechend geeigneten Bedingungen
lagern. Siehe
Abschnitt
6.
C411-02-885 Issue H/Ausgabe H/Version H
3
Installation
3.1
Déballage et vérifications
Retirez tous les matériaux d'emballage et obturateurs
de protection et vérifiez que la vanne PVEK n'est pas
endommagée.
En cas d'endommagement, vous devez prévenir votre
fournisseur et le transporteur par écrit, dans les trois
jours, en signalant le numéro de code de la vanne ainsi
que votre numéro de commande et le numéro de facture
de votre fournisseur. Conservez les matériaux
d'emballage en vue d'un examen ultérieur. N'utilisez
pas cette vanne si elle est endommagée.
Si la vanne ne doit pas être utilisée immédiatement,
remettez en place les obturateurs de protection et
conservez la vanne dans les conditions adéquates,
comme indiqué à la
Section
6.
Page/Seite/Page 17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pv16ekPv25ekPv40ek

Table des Matières