Hot Water; Regulating The Boiler Temperature; Cleaning And Maintenance - La Pavoni CASABAR PID Manuel D'utilisation

boiler with water and bring the
machine to the correct operating
temperature. Otherwise, the coffee
may have a burnt taste.
• Place an empty cup on the grid. Do
not insert the filter holder. Fill the cup
with water by moving the lever switch
(15) to position "I". Once the cup is full,
move the coffee lever switch (15) to
position "0". It is now possible to brew
more coffee.
4–4. HOT WATER
• Make sure that you have carried out all
the operations in section 4.1.
• Place a container under the hot water /
steam nozzle
• Open the knob (4) and move the coffee
/ hot water lever switch (15) to position
"I"; water will immediately come out of
the steam/hot water nozzle (6).
• Once the required amount of water
has been dispensed, move the coffee /
hot water lever (15) back to position "0"
and close the knob (4).
• After dispensing hot water, make sure
that there is still water in the tank (1).
4–5. REGULATING THE BOILER
TEMPERATURE
• The LPSCSR02 model is fitted with a
PID temperature controller (11).
• PID temperature controllers regulate
the boiler temperature.
• The PID temperature controller is
factory set to 92°C.
• To adjust the setting proceed as
follows:
- press the button
"PRG" appears on the display, press
the button ;
- when the temperature of the boiler
appears on the display, use the
buttons and to set the
temperature, from a minimum of 80°C
• Before carrying out any cleaning or
• Do not immerse the coffee machine in
• Let the coffee machine cool down
CLEANING THE FILTERS AND FILTER
HOLDERS
• Regularly check the holes in the
• Place approximately one litre of
CLEANING THE STEAM NOZZLE
• To avoid altering the taste of the drinks
; as soon as
• Then clean thoroughly with a damp
22
to a maximum of 120°C.
- 3 seconds after having pressed the
last button, the value is memorized
and the display indicates the
temperature.
If the temperature threshold is set
too high, the display will start to
flash when coffee is dispensed.

5. CLEANING AND MAINTENANCE

maintenance, unplug the power cable
from the power outlet without pulling
the cable.
water or other liquids.
before cleaning.
filters in order to remove any coffee
deposits.
boiling water and four teaspoons of
coffee machine cleaner in a suitable
container. Immerse the filters and
filter holders in the solution for 20-30
minutes. Then rinse thoroughly under
running water.
to be heated and to prevent the hole
at the end of the steam nozzle (6) from
becoming clogged, after use, turn
the steam knob to dispense a small
amount of steam and remove any milk
from the inside of the nozzle.
cloth.