La Pavoni CASABAR PID Manuel D'utilisation page 25

The coffee is dispensed in
drops
The coffee leaks between
the boiler unit and the filter
holder
No froth forms on the coffee
The coffee is too cold
The coffee is too hot
The machine does not
dispense steam
1. The coffee is too finely
ground
2. There is too much coffee
3. The coffee has been
compacted too much
1. The filter holder is not
inserted correctly
2. There is too much coffee
in the filter basket
3. The edge of the filter
holder has not been
cleaned
4. The group head gasket is
worn
1. The coffee blend is not
suitable for this type of
machine
2. The grinding is unsuitable
3. There is not enough
coffee
1. The machine had not
reached the correct
temperature
2. The filter holder had not
been pre-heated
3. The cups have not been
preheated
4. The thermostat is not
working within the
required range
5. The PID temperature
controller (11) is not
working within the
required range
1. The PID temperature
controller (11) is not
working within the
required range
1. The circuit has not been
filled
2. The hole at the end of the
steam nozzle is clogged
3. No water in the tank
4. The turbo steam nozzle
has not been inserted
properly
25
1. The coffee should be
ground more coarsely
2. Reduce the amount of
coffee
3. Tamp the coffee less
1. Insert it properly
2. Reduce the amount of
coffee
3. Remove coffee residues
from the edge of the
filter holder and clean the
group head gasket
4. Contact the SERVICE
CENTRE
1. Replace the coffee
2. Adjust the coffee grind
3. Increase the amount
of coffee and compact it
properly
1. Follow the instructions
given in section 4.1– 4.2
2. The filter holder should
be heated at the same time
as the water, see section 4.1
3. Heat the cups properly on
the cup warmer (2)
4. Contact the SERVICE
CENTRE.
5. Set the value for the PID
temperature controller
1. Set the value for the PID
temperature controller
1. See section 4.3 –
dispensing steam
2. Clean the hole with a
needle
3. See section 4.1
4. Insert the turbo steam
nozzle properly