Product Output Control(S); Operation Of The Leds - ADEUNIS ARF8283A Guide Utilisateur

LoRaWAN DELTA P - Guide utilisateur / User guide version V1.0.0

2.1.8 Product output control(s)

The product allows configuring all or part of the digital outputs in order to control them from the network by a downlink frame as shown in the
following diagram:
Product in standby
Event or period
reached ?
Yes
Send frame 0xXX
Frame reception 0x60
ou 0x61
Update states of digital
input configured at the
output

2.2. Operation of the LEDs

Mode
Product in Park mode
Magnet detection process (1 to 6 seconds)
Starting the product (after detection of the
magnet)
JOIN process
Switching to command mode
Low battery power level
Defective product (factory return)
Product in REPLI mode
The parameters associated with this operating mode are:
• The configurations of the different digital inputs/outputs (registers 380 and 382)
The complete list of registers may be found in section 3.4.
Example :
No
Register Value coding
S380 Hexadecimal
S382 Hexadecimal
In this example, I/O 2 is configured as an output with a default state of 1.
Red LED State
Off
Off
Off
During the JOIN phase:
flashing: 50 ms ON / 1s OFF
If JOIN phase completed (JOIN ACCEPT) :
flashing: 50 ms ON / 50 ms OFF (x6)
Fixed on
Flashing (0.5 s ON every 60s)
Fixed on
Flashing (100 ms ON/ 100 ms OFF) x2 every 5 s -
Value Result value
0x73 Configuration of the digital input/output 1:
• Periodic mode
• Counting of high and low fronts
• 1 second guard period
0x05 Configuration of the digital input/output 2:
• Output (default state= 1/CLOSE)
• No on-call period
Green LED State
Off
ON as soon as the magnet is detected for up
to 1 second
Fast flashing 6 cycles 100 ms ON/ 100 ms
OFF
During the JOIN phase:
flashing: 50 ms ON / 1s OFF (just after red
LED)
If JOIN phase completed (JOIN ACCEPT):
flashing: 50 ms ON / 50 ms OFF (x6) (just
before red LED)
Fixed on
-
-
FR
EN
Page 65 of 88