Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
sigfox Pulse - Guide utilisateur / User guide version V2.0.0
1. PRODUCT PRESENTATION
IMPORTANT NOTE: the SIGFOX PULSE can only be started or restarted using a magnet.
Description
•
sigfox Pulse is a ready to use radio transmitter that can be used to transform any type of meter into a wireless meter (smart meter).
•
This product meets the needs of users who require to remotely monitor the consumption of different fluids (water, gas, electricity, heat ...)
or any other phenomenon with an impulse interface (rain gauge, odometer...).
•
The use of the sigfox protocol allows the user to integrate the sigfox Pulse into any network that is already deployed.
•
Two meters 3 wires or one meters 5 wires may be controlled by a single SIGFOX PULSE transmitter thus permitting a significant reduction
in implementation and deployment costs.
• The product emits the data from the meters periodically with or without history. It allows also the detection of tamper, and leakage, and
the flow calculation with transmission possibilities on exceeding high or low thresholds.
•
The configuration of the transmitter is accessible by the user via a micro-USB port or remotely via the sigfox network, allowing in particular
a choice of modes of transmission, periodicity or triggering thresholds.
• The sigfox Pulse is powered by a non-replaceable internal battery.
IMPORTANT NOTE: The sigfox Pulse can transmit measurements from the meters but does not power them (except TOR version).
Package composition
The product is supplied in a cardboard package containing the following elements:
•
Upper case, electronic board, case plate.
•
Compression gland with nut, 3 compression seals, 2 CBLZ 2.2 x 19mm screws, 2 Fischer SX4 plugs.
1.1. General description
Casing base
Antenna
2 holes for
passing collars
through
4 fastening holes
Rail-DIN unlocking
lever
Casing base detail
FR
EN
Cables outlet
packing gland
Page
57
of 100
Publicité
Table des Matières
