Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
sigfox ANALOG - Guide utilisateur / User guide version V2.0.0
1.
PRODUCT PRESENTATION
IMPORTANT NOTE: The sigfox ANALOG can only be started with a magnet.
Description :
• The adeunis® sigfox ANALOG is a ready-to-use radio transmitter enabling any type of 0-10V or 4-20mA sen-
sor to be converted into a wireless communicating sensor.
FR
• This product meets the needs of users who need to remotely monitor data of any kind (temperature, pressure,
level, humidity, CO², speed, brightness, opening, etc.)
• The use of the sigfox protocol allows you to integrate the sigfox ANALOG into any network that is already
deployed.
• Two sensors can be supported by a single sigfox ANALOG transmitter.
• The product transmits the data from the sensors either periodically or in an event-related way based on top or
bottom thresholds or on detection of a change of state on its digital inputs.
EN
• The configuration of the transmitter is accessible by the user via a micro-USB port, allowing in particular a
choice of modes of transmission, periodicity or type of interface (0-10V or 4-20mA).
• The sigfox ANALOG is powered by a replaceable internal battery.
IMPORTANT NOTE : the sigfox ANALOG can transmit measurements from the sensors but does not feed them
(except the digital version).
Composition of the package
The product is supplied in a cardboard box containing the following items:
top casing, electronic card, casing base plate,
cable gland, 3 gland seals, 2 CBLZ 2.2 x 19mm screws, 2 Fischer SX4 plugs
1.1. General description
Casing base
Antenna
2 holes for passing
collars through
4 fastening holes
Rail-DIN unlocking
lever
Casing base detail
Cables outlet
packing gland
Page
50
of 86
Publicité
Table des Matières
