Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
sigfox ANALOG - Guide utilisateur / User guide version V2.0.0
3.
DEVICE CONFIGURATION
The device can be configured using the USB connector. This connection allows you to communicate with the device
via a virtual com port and to transmit AT commands in order to modify the parameters of the device.
WARNING : the USB connection does not supply power to the product, it induces a consumption of the product as
long as the one is connected. It is therefore important not to leave the product connected too long.
FR
3.1. Connecting the device to a computer
Connect the product to the USB input of a computer. The product has a Type B micro USB connector.
During connection, the device must be recognised by the computer as a Virtual Com Port (VCP) device.
Using Windows: Verification that the device has been recognised to be functioning properly can be obtained by
consulting the device manager. You should see the USB series device with a corresponding COM port number appear
during connection.
EN
If you are not able to see a device of this type, you must install the USB driver for this device, available to download from our website:
https://www.adeunis.com/produit/analog/
Select:
•
Driver USB-STM32_x64, if your computer is a 64 bits system
•
Driver USB-STM32, if your computer is a32 bits system
Page
62
of 86
Publicité
Table des Matières
