Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
sigfox Pulse - Guide utilisateur / User guide version V2.0.0
3.
DEVICE CONFIGURATION
The device can be configured using the USB connector. This connection allows you to communicate with the device via a virtual com port and
to transmit AT commands in order to modify the parameters of the device.
WARNING : the USB connection does not supply power to the product, it induces a consumption of the product as long as the one is connec-
ted. It is therefore important not to leave the product connected too long.
FR
3.1. Connecting the device to a computer
Connect the product to the USB input of a computer. The product has a Type B micro USB connector.
During connection, the device must be recognised by the computer as a Virtual Com Port (VCP) device.
EN
Using Windows: Verification that the device has been recognised to be functioning properly can be obtained by consulting the device manager.
You should see the USB series device with a corresponding COM port number appear during connection.
If you are not able to see a device of this type, you must install the USB driver for this device, available to download from our website:
https://www.adeunis.com/produit/pulse/
Select:
•
Driver USB-STM32_x64, if your computer is a 64 bits system
•
Driver USB-STM32, if your computer is a32 bits system
Page
70
of 100
Publicité
Table des Matières
