LoRaWAN DELTA P - Guide utilisateur / User guide version V1.0.0
5. Installation and Start-up
5.1. Opening and closing the unit
Remove the screws
5.2. Configuring the device
Pull the cable gland to remove
the flange
To set up the product:
1. Open the case (paragraph 5.1)
2. Connect the micro-USB port
3. Configure your product as described in the paragraph.
To start the product:
Once the product is closed, position the magnet 6 seconds in front of the marking «2»
on the case. The green LED lights up and flashes rapidly. Once the product starts up
fully, it sends its status frames and then, after the defined transmission period time, a
data frame.
Reinsert the card by following the
guide rails inside the box
FR
EN
Page
83
of 88