Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Sigfox DELTA P - Guide utilisateur / User guide version V2.0.1
3.
REGISTERS AND FRAME DESCRIPTION
To know the content of the registers and of each frames (uplink and downlink) of the product, refers to the TECHNICAL REFERENCE MANUAL
of the DELTA P, available on the adeunis website:
4. CONFIGURATION AND INSTALLATION
4.1. Configuration and installation of the transmitter
To configure the product, it is recommended to use the IoT Configurator (android and Windows application).
- Google Play :
https://play.google.com/store/apps/details?id=com.adeunis.IoTConfiguratorApp
- Windows 10:
https://www.adeunis.com/telechargements/
EN
To configure the product using AT Command or install the product, please refers to the INSTALLATION GUIDE adeunis available on the web-
site.
The product can be also configured via the network sending downlinks. To do it, refer to the TECHNICAL REFERENCE MANUAL of the DELTA P,
available on the adeunis website:
4.2. Installation on a ventilation system
Since Air Handling Unit (AHU) are usually in enclosed areas or on roofs (Rooftop package unit), certain installation rules must be followed to
ensure proper operation of the product:
•
Do not position the product in a location where it will be subject to temperatures outside the product's operating temperature range.
•
Do not position the product directly next to the ventilation system (about 20 cm laterally or the antenna above the box) as these are
mainly made of metal, which may greatly reduce the range of radio waves and therefore the transmission and reception quality of the
product.
•
Avoid the use of tubes longer than 2 meters as this may impact the measurements made (longer pressure times).
•
Position the product higher than the box to be monitored so that the cables are always below the product and thus prevent any conden-
sation (due to humidity) from entering the product and damaging it.
•
Take care when installing the tubes so that they are not pinched or pierced as this will impact the measurements made.
4.3. Connecting the outer tubes
In order to ensure optimal operation of the product it is necessary to connect it correctly. The outer tubes are not supplied with the product.
Find below the ribs to be able to choose suitable tubes:
https://www.adeunis.com/en/produit/delta-p-2/
https://www.adeunis.com/en/produit/delta-p-2/
20 cm
6 mm
Page
48
of 50
Publicité
Table des Matières
