Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
sigfox MODBUS MASTER - Guide utilisateur / User guide version V2.0.0
3. REGISTERS AND FRAMES
To know the content of all the registers and for each frame of the product (uplink or downlink) please refer to the TECHNICAL REFERENCE
MANUAL of the sigfox MODBUS MASTER, available on the dedicated product page:
face-for-modbus-slaves/
4. CONFIGURATION AND INSTALLATION
4.1. Configuration and installation of the transmitter
To configure the product locally, it is advised to use the IoT Configurator, an android and windows application created by adeunis.
- Google Play :
https://play.google.com/store/apps/details?id=com.adeunis.IoTConfiguratorApp
- Windows 10:
https://www.adeunis.com/en/downloads/
The product can be configured locally or remotely through the network sending it specific downlink frames. To know which frame use or the
format of each frame, please refer to the TECHNICAL REFERENCE MANUAL of the sigfox MODBUS MASTER, available on the dedicated product
page:
https://www.adeunis.com/en/produit/modbus-interface-for-modbus-slaves/
If you want to configure your product through AT command or know how to install your product, refer to the INSTALLATION GUIDE adeunis®.
4.2. Modbus specificities in the IoT Configurator
4.2.1 Test Modbus read, test reading into slave registers
To help to configure or install the MODBUS product, a function to test the reading of a slave has been integrated into the advanced mode of the
IoT Configurator.
Before having wired the product to one or several slaves, it is possible to test the read-
ing into registers of a slave completing the following fields :
•
Baud Rate
•
Parity
•
Stop bits
•
Slave address
•
First register address
•
Number of registers
•
Type of registers (holding or input)
The product will test the link and the reading into registers and will show you the
response from the slave.
This function enables you to confirm a configuration before to implement it into the product and switch it to PRODUCTION mode.
4.2.2 Test Modbus write, test the writing into a slave register
To help to configure or install the MODBUS product, a function to test writing into the register of a slave has been integrated into the advanced
mode of the IoT Configurator.
Before having wired the product to one pr several slaves, it is possible to test the writing
function of the product completing the following fields:
•
Baud Rate
•
Parity
•
Stop bit
•
Slave address
•
Register address
•
Value to write into the register
The product will test the link and the writing into the concerned register and will show
you the response from the slave.
This function enables you to confirm the link between the device and the slave register or to write directly in a slave register.
https://www.adeunis.com/en/produit/modbus-inter-
FR
EN
Page
41
of 43
Publicité
Table des Matières
