Description Of The Registers; Function Registers - ADEUNIS WMBUS Pulse Guide Utilisateur

WMBUS Pulse - Guide utilisateur / User guide version V2.2.0

3.4. Description of the registers

On switching on the product works according to the last saved configuration (Factory Configuration if it is the first start, or if this configuration
has not been changed).
Commands such as Modification TTY<n>=<M> or ATR allow you to change the content of the registers: <n> representing the number of the
register and <m> the value to be assigned. This latter is either a decimal value or a hexadecimal value consistent with the «encoding» column
of the tables below.
FR
Examples :
• ATS300=6 assigns the decimal value 6 in register 300
• ATS302=2 assigns the hexadecimal value 0x02 in register 302
It is imperative to save the parameters with the command AT&W before exiting the Command mode otherwise all changes will be lost.
EN

3.4.1 Function registers

The list of registers below allows you to change the behavior of the product application.
Register Description
Transmission period of the
3S00
Keep Alive frame
S301 Transmission period of data
sensors
S304 PIN code
S306 Global operation
Coding
Ignored value, the period is set to 24 hours (not configurable) in OPERA-
---
TION mode and 5 minutes in TEST mode
Decimal Default value: 1440
Min/max : 1 to 1440
Unit:
x 1min if S306=1
x 20s if S306=2
Decimal Default value : 0 (disabled)
Min/max : 0 to 9999
PIN code used with ATPIN command.
Value 0 disables the PIN code.
IMPORTANT: The product does not have a mechanism to unlock
the PIN code if it is activated and the code is forgotten.
Decimal Default: 0
Allows the product to be switched into one of the following modes:
• 0: PARK mode
• 1: Production mode
• 2: TEST mode
• 3: REPLI mode
Details
Page 74 of 99