Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WMBUS Pulse - Guide utilisateur / User guide version V2.2.0
2.1.4 REPLI mode
The product enters this very low consumption mode following the detection of a level of battery that is too low. In this mode the product wakes
up every 5 seconds to make the red LED flash twice.
The replacement of the battery (if the product is a replaceable battery version) followed by the application of the magnet takes the product out
of this mode to return it to the operating mode.
2.2. Application operation
2.2.1 Periodic transmission
The product allows the measurement and the periodic transmission of the values of the sensors according to the following diagram:
No
The settings associated with this mode of operation are:
•
Transmission period (register 301)
•
Enabling and Configuring inputs (register 320)
•
Anti-bounce timer period (registers S322)
A complete list of the registers can be found in paragraph 3.4.
Eg:
Register
Value encoding
S301
Decimal
S320
Hexadecimal
S322
Hexadecimal
Product in standby
Period
reached?
Yes
Send frame 0x46
Value
60
0x39
0x57
Detected
No
and valida-
ted pulse
?
Yes
Counting of the
impulse
Result
Periodic mode with a period of 60x1min = 60 minutes
Channel A :
•
Activated
•
Meter other than gas
•
Tamper input activated
Channel B :
•
Activated
•
Gas meter
•
Tamper input disabled
Anti-rebound :
•
Channel A = 500ms
•
Channel B = 100ms
FR
EN
Page
63
of 99
Publicité
Table des Matières
