Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WMBUS Pulse - Guide utilisateur / User guide version V2.2.0
0x30
Keep Alive frame
0x46
Data Frame
0x47
Alarm frame
0x48
Periodic frame with 1 hour-history
0x48 (x3) Periodic frame with 24 hours-his-
tory
• 24 hours elapse since the start-up of the product or since the last transmission of this
frame (5 minutes in TEST mode)
• Start-up of the product (RUN mode)
• Exit from the configuration mode (AT command)
• Transmission period reached (period defined by register S301)
Exceeded flow threshold on one of the two channels (sending only if the exceeded flow
control is enabled by writing a non-zero value in the S326 or S327 registers).
1 hour elapses since the start-up of the product or since the last transmission of this frame
This frame is sent only if the history feature is activated in register S321.
24 hours elapse since the start-up of the product or since the last transmission of this frame
This frame is sent only if the history feature is activated in register S321.
FR
EN
Page
87
of 99
Publicité
Table des Matières
