Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WMBUS Pulse - Guide utilisateur / User guide version V2.2.0
2. PRODUCT OPERATION
2.1. Global Operation
Important: adeunis® use the most significant byte first format.
The product has several operating modes:
FR
EN
COMMAND MODE
2.1.1 PARK mode
The product is delivered in PARK mode, it is in standby mode and its consumption is minimal. To switch the product out of the Park* Mode pass
a magnet across it for a duration higher than 6 seconds. The green LED illuminates to indicate the detection of the magnet and then flashes
quickly during the product starting phase.
The device then sends its configuration and data frames (see paragraph 4.1).
2.1.2 COMMAND mode
This mode allows the user to configure the registers of the product.
To enter this mode, connect a cable to the micro-USB port of the product and enter the command mode by an AT command (see paragraph 3).
2.1.3 OPERATING mode
There are two possible modes of operation:
•
TEST mode:
This mode allows the user to perform tests of the product more quickly by reducing the time scales of production mode and modifying the
behavior of the LEDs (see paragraph 2.2.5). WARNING : this mode has an highly impact on the device autonomy
•
PRODUCTION mode:
This mode allows the user to operate the product in its final use. It should allow a maximum of autonomy to the product.
To switch from one mode to the other the user changes the value of a register
Command sen-
ding by serial link
PRODUCTION MODE
COMMAND MODE
PARK MODE
Presence of a magnet
on the product >6s
OPERATING MODE
Automatic if battery
too low
REPLI MODE
COMMAND MODE
TEST MODE
Presence of a magnet
on the product >6s
Replacing the battery
*Only on changeable battery version, on request
The return to the pro-
duction mode is done by
the ATO command or by
disconnecting the USB
cable.
Page
62
of 99
Publicité
Table des Matières
