Product Operation; Global Operation; Park Mode; Command Mode - ADEUNIS Sigfox RC1 ANALOG Guide Utilisateur

sigfox RC1 ANALOG - Guide utilisateur / User guide version V2.0.1
2.

PRODUCT OPERATION

2.1. Global Operation

Important: adeunis® use the most significant byte first format.
The product has several operating modes:
Command sen-
ding by serial link

COMMAND MODE

2.1.1

PARK mode

The product is delivered in PARK mode, it is in standby mode and its consumption is minimal. To switch the prod-
uct out of the Park* Mode pass a magnet across it for a duration higher than 6 seconds. The green LED illuminates
to indicate the detection of the magnet and then flashes quickly during the product starting phase.
The device then sends its configuration and data frames (see paragraph 4.1).
2.1.2 COMMAND mode
This mode allows the user to configure the registers of the product.
To enter this mode, connect a cable to the micro-USB port of the product and enter the command mode by an AT
command (see paragraph 3).
2.1.3

OPERATING mode

There are two possible modes of operation:
• TEST mode:
This mode allows the user to perform tests of the product more quickly by reducing the time scales of production
mode and modifying the behavior of the LEDs (see paragraph 2.2.5). WARNING : this mode has an highly im-
pact on the device autonomy
• PRODUCTION mode:
This mode allows the user to operate the product in its final use. It should allow a maximum of autonomy to the
product.
To switch from one mode to the other the user changes the value of a register
PARK MODE
OPERATING MODE
REPLI MODE
PRODUCTION MODE
COMMAND MODE
TEST MODE
Presence of a magnet
on the product >6s
Presence of a magnet
on the product >6s
Automatic if battery
too low
COMMAND MODE
Replacing the battery
The return to the
production mode
is done by the ATO
command or by dis-
connecting the USB
cable.
Page 55 of 86
FR
EN