Description Of The Frames; Uplink Frames; Fixed Bytes; Product Configuration Information Frames - ADEUNIS Sigfox RC1 ANALOG Guide Utilisateur

sigfox RC1 ANALOG - Guide utilisateur / User guide version V2.0.1
4.

DESCRIPTION OF THE FRAMES

4.1. Uplink frames

All of the uplink frames of the product to the network (uplink) always have a size of 11 bytes.
4.1.1

Fixed bytes

FR
The first two bytes of the frame are systematically dedicated to indicate the frame code and the status as present-
ed below:
0 1
Code Statut
EN
4.1.1.01 Byte code
This byte contains the code associated with the frame to facilitate its decoding by the data system.
4.1.1.02 Status Byte
The status byte is broken down in the following way:
Alarm Status
No Error
Configuration
done
Low bat
HW Error
Details of the fields:
• Frame counter: Frame counter, it increments at each transmission and allows the user to see quickly if a frame
has been lost. It counts from 0 to 7 before looping back.
• HW: This bit is set to 1 when a hardware error has occurred, for example a writing problem in the EEPROM, a
reading problem on the ADC, etc. The product must be returned to the service dept.
• Low Bat: bit at 1 if the battery voltage is less than 2.5V, otherwise 0. This information remains permanent.
• Confg: bit at 1 if a configuration was carried out during the last downlink frame, otherwise 0. This bit returns
to 0 as from the next frame.
E.g.:
A value of the status byte equal to 0xA2 (= 10100010 in binary) gives:
• Bit 7 at 5 = 101 = 0x05 i.e. a frame counter at 5
• Bit 4 at 0 = 00010 in binary i.e. a low battery alarm
4.1.2

Product configuration information frames

Following reception of a downlink frame with the code 0x01 or on switching to the operating mode (from the Park
or Command Mode), the next frame (0x10) representing the application configuration of the product is transmit-
ted:
0 1
Code Status
0x10 Cf
Status
0x10 0xA2
Description of the frame:
• Byte 2: register 300, periodicity of the Keep Alive frame, expressed in tens of minutes
• Byte 3: register 301, periodicity of the transmission, expressed in tens of minutes
2 3
Bit 7 Bit 6 Bit 5
Frame Counter
0x00 to 0x07
2 3
S300 S301 S320
0x48 0x00 0x02
4 5 6
PAYLOAD
Bit 4 Bit 3
Reserved Reserved
X X
X X
X X
X X
4 5 6
PAYLOAD
S321 S322
0x03 0x01
7 8 9
Bit 2 Bit 1
HW Low Bat
0 0
0 0
0 1
1 0
7 8 9
S323 S306 X
0x02 0x01
10
Bit 0
Config.
0
1
0
0
10
X
Page 68 of 86