Installation And Use; Correct Positioning Of The Product; Types Of Fastenings; Tube Or Mast Fastenings - ADEUNIS Sigfox RC1 ANALOG Guide Utilisateur

sigfox RC1 ANALOG - Guide utilisateur / User guide version V2.0.1
6.

INSTALLATION AND USE

6.1. Correct positioning of the product

There are two key rules for optimizing radio ranges.
• The first one consists of positioning your product as high as possible.
• The second one consists of limiting the number of obstacles in order to avoid excessive attenuation of the
radio wave.
Position: To the extent possible, install the transmitter at a minimum height of 1.50 m and do not attach it to
the wall.
Obstacles: Ideally, the product must be 20 cm away from any obstacle and, if possible, near an opening (the
closer the obstacle is, the more the emitted power will be absorbed). All the materials encountered by a radio
wave will attenuate it. Bear in mind that metal (metal cabinets, beams, etc.) and concrete (reinforced concrete,
partitions, walls, etc.) are the most critical materials for the propagation of radio waves.

6.2. Types of fastenings

The product offers 3 fastening methods that enable numerous ways of positioning it depending on the environment
where it has to be deployed.
6.2.1 Tube or mast
fastenings
As explained in section 4.1, the
best radio performance is achieved
by positioning the product as high
as possible.
The fastening collar fastenings en-
able the product to be fastened on
a mast or tube under completely
safe conditions
20 cm
Optimised positioning
Low radio range
Holes for faste-
ning collars
FR
EN
Page 79 of 86