Product Operation; Global Operation; Park Mode; Command Mode - ADEUNIS PULSE IP68 V4 Sigfox RC1 Guide Utilisateur

sigfox RC1 PULSE IP68 - Guide utilisateur / User guide version V4.0.0

2. PRODUCT OPERATION

2.1. Global Operation

Important: adeunis® use the most significant byte first format.
The product has several operating modes:
FR

COMMAND MODE

EN

2.1.1 PARK mode

The product is delivered in PARK mode, it is in standby mode and its consumption is minimal. To switch the product out of the Park* Mode pass
a magnet across it for a duration higher than 6 seconds. The green LED illuminates to indicate the detection of the magnet and then flashes
quickly during the product starting phase.
The device then sends its configuration and data frames.
2.1.2 COMMAND mode
This mode allows the user to configure the registers of the product.
To enter this mode, connect a cable to the micro-USB port of the product and enter the command mode by an AT command.

2.1.3 PRODUCTION mode

This mode allows the user to operate the product in its final use. It should allow a maximum of autonomy to the product.

2.1.4 Management of the low battery

When the product detects that the battery is not anymore in capacity to deliver the energy needed to send a frame (extreme temperatures or
end-of-life of the battery) it waits to be in capacity to transmit. If it detects that the delay generated is longer than 1 minute it informs the user
via the "battery low" flag in the status byte of each frame.
Product should
send a frame
The battery low alarm is switching off if the battery is replaced or when the temperature conditions are favorable for the proper functioning of
the battery.
Command sending by
serial link
PRODUCTION MODE
Auto adaptation (cf
management of the
low battery)
yes
Battery is
The product is
no
sufficient
waiting to be
to send the
able to emit
frame
?
PARK MODE
Presence of a magnet
on the product >6s
Send "battery low" flag
OFF (dead battery)
yes
Delay
no
is lower than 1
minute ?
"Low battery"
no no
alarm appears in
sends its frame
status byte
The product
Page 40 of 52