Operation Of The Leds - ADEUNIS PULSE IP68 V4 Sigfox RC1 Guide Utilisateur

sigfox RC1 PULSE IP68 - Guide utilisateur / User guide version V4.0.0
Example :
Register Value encoding
S320 Hexadecimal
FR
S322 Hexadecimal
S325 Decimal
EN
S328 Decimal
S329 Decimal
S330 Decimal
S331 Decimal
In this example, all the periods during which the flow rate on the channel A is less than 10 pulses / hour are considered as periods of zero flow.
If the total daily number of zero flow periods is less than 3 then it is considered that there is a leak on the channel A.

2.3. Operation of the LEDs

Mode
Product in Park mode
Magnet detection process (1 to 6 seconds)
Product start (after detection of the magnet) OFF
Switching to the Command mode
Product faulty (return to factory)
Value Result
0x39 Channel A :
• Activated
• Meter other than gas
• Tamper input activated
Channel B :
• Activated
• Gas meter
• Tamper input disabled
0x57 Anti-bounce :
• Channel A = 500ms
• Channel B = 100ms
60 Flow calculation period (channels A and B) = 60min
10 Leak threshold (channel A) = 10 pulses par hour
0 Leak threshold (channel B) = 0 pulse par hour
3 Daily periods number under the leak threshold (channel A) = 3
5 Daily periods number under the leak threshold (channel B) = 5
LED red state
OFF
OFF
Continuously lit
Fixed ON
LED green state
OFF
ON from detection of the magnet up to a
maximum of 1 second
Rapid flashing 6 cycles, 100 ms ON / 100
ms OFF
Continuously lit
Page 48 of 52