Device Operation; Operating Modes; Park Mode; Command Mode - ADEUNIS Sigfox Smart Building MOTION Guide Utilisateur

Sigfox Smart Building MOTION - Guide utilisateur / User guide version V1.0.1

2. DEVICE OPERATION

2.1. Operating modes

IMPORTANT NOTE: adeunis® uses the Big-Endian data format
The device has several operating modes
FR
EN

COMMAND MODE

2.1.1 PARK MODE

The device is delivered in PARK mode, it is thus in standby mode and its consumption is minimal. Exit PARK mode by pressing and holding the
button for more than 5 seconds. The green LED lights up to indicate the detection of the pressed button and then flashes rapidly during the
device start-up phase.
The device then sends its configuration and data frames (see section 4.1).
2.1.2 COMMAND MODE
This mode is used to configure the device registers. There are two ways to enter this mode:
- Open the adeunis® IoT Configurator application, connect a cable to the device's micro-USB port and connect it to the computer or
mobile phone.
- Connect a cable to the micro-USB port of the device and enter command mode via an AT command (see paragraph 3).
The output of the COMMAND mode is via the ATO command or the USB cable disconnection. The device will then return to its previous mode,
i.e. PARK or OPERATING

2.1.3 OPERATING MODE

This mode allows the device to work in its intended end use.

2.1.4 REPLI MODE

The device enters this very low power mode due to the detection of a low battery level. In this mode the device wakes up every 5 seconds to
flash the red LED twice.
Replacing the battery and then pressing and holding the button (2 seconds) will exit this mode and return to OPERATING mode.
Sending com-
mands via
DISTRIBUTED BY TEXIM EUROPE
PARK MODE
Long press on the
button (5 sec)
OPERATING MODE
Automatic if battery
too low
REPLI MODE
Long press on the button
(5 sec)
Replacing the battery
Page 52 of 83