Installation And Start-Up; Opening And Closing The Unit; Configuring The Device - ADEUNIS Sigfox Smart Building MOTION Guide Utilisateur

Sigfox Smart Building MOTION - Guide utilisateur / User guide version V1.0.1

5. Installation and Start-up

5.1. Opening and closing the unit

5.2. Configuring the device

Insert a flat screwdriver into the opening on the top
of the casing and press. The casing opens in two and
the front panel comes off.
CAUTION: Press gently and straight so as not to
damage the casing
Front face
To configure the device:
1. Open the unit (paragraph 5.1)
2. Insert the micro-USB
3. Configure your device as described in paragraph 3.
DISTRIBUTED BY TEXIM EUROPE
To close the unit, insert the bottom of
the front panel first and clip the top of
the casing
2
1
FR
EN
Page 75 of 83