LoRaWAN DELTA P - Guide utilisateur / User guide version V1.0.0
5.7.3 Fixing Rail-DIN
This system, integrated into the case, allows the product to be fixed on a standard 35mm rail
•
To install the housing, place the upper inserts on the rail and lower the product to clip it
in.
•
To remove the product, pull the unlocking lever down and disengage the product from
the rail.
5.8. Connecting the outer tubes
In order to ensure optimal operation of the product it is necessary to connect it correctly. The outer tubes are not supplied with the product. Find
below the ribs to be able to choose suitable tubes:
In order to ensure proper connection of the product, take care to connect
the tube positioned where the pressure is highest on the P+ support
(indicated on the base plate) and to connect the tube going into the section
with the lowest pressure on the P- support.
5 mm inside diameter tubes (not
supplied)
P+
P-
6 mm
In order to avoid premature degradation of tubes exposed to the
sun, Adeunis strongly recommends covering the tubes with an
anti-UV sheath.
FR
EN
Page
87
of 88